Paladin DesignBase Advanced Training * (Prerequisite: DesignBase Basic Training)
Dates:
-
May 2 - 4
- July 11- 13
- October 10 - 12
Click to enlarge image
COURSE TOPICS:
Day 1:
• Review System Modeling concepts;
• Review System Analysis: per unit method, symmetrical components;
• IEEE Standards;
• Subtransient, transient and steady state short circuit current;
• Short Circuit Reports;
• Circuit Duty, Switching equipment capabilities;
• Protective Device Evaluation;
• Numerical examples;
• Protective Device Coordination (PDC);
• Protection principles;
• Methods of coordination
• Performing a PDC study using EDSA PDC program;
• Numerical examples.
Day 2:
• Introduction to power quality;
• Linear & Non-Linear Loads;
• Harmonics based power quality investigation using EDSA;
• Frequency Scan;
• Transformers and K Factors;
• Capacitors & Resonance;
• The Harmonics Program Control Interface;
• Modeling Harmonics Sources in EDSAT;
• Adding Filters (Manually, Auto Filter Sizing);
• Phase Shifting Transformers;
• Generic approach on power quality investigation;
• Practical Exercises.
Day 3 :
• Steady state models and dynamic models;
• Generator dynamic models;
• Motor dynamic models;
• Governor models;
• AVR models;
• Modeling disturbances in EDSA Adv. Transient program;
• EDSA Universal Logic Controller: built dynamic models;
• Practical Exercises: bus transfer, plant start up, motor sequencing, dynamic motor starting; faults, voltage sags, modeling relays, CBs, fuses, etc.
Copyright 2008 EDSA Micro Corporation. All rights reserved. "EDSA," "Paladin," and "Power Analytics" are trademarks of EDSA Micro Corporation. All other trademarks, names, logos are the property of their respective holders. EDSA gratefully acknowledges governmental and regulatory agencies whose names, photos, logos, award programs, or certification programs are listed herein; such use does not constitute their endorsement of EDSA or its products by these agencies.
